Peumatic Grouting pump is designed for stress and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes in order to reinforce the free rock mass. The maximum grain measurement can not exceed 0.2 mm.
Grouting pump operation and upkeep is simple, protected and reliable. This pump is used in mines operating under tough conditions as a end result of it is dependable and explosion-proof.
Basic Pneumatic Grouting pump include: An air inlet, the pneumatic cylinder, mounting base frame and stand, pressure gauge, pumping cylinder, outlet with fast release coupling and wheels.
How it works
Pneumatic stress within the air cylinder exerts a excessive strain on the grout mixture which finally ends up in ejection of grout with a high strain and velocity. The valves of the air cylinder in the pump perform routinely to actuate the cylinder. The pneumatic cylinder then moves the plunger up and down to finish the pumping cycle.
Price break may be pushed even with out Electrical power supply in remote areas by utilizing engine driven compressor.
Applications
The pump is majorly utilized in development and mining industry for injecting material into extensive and medium measurement hole in beams, columns ,basement walls and flooring, carry shaft concrete wall fill-up etc. In mining business it’s used to replenish cement answer where there’s a hole exists between construction and rock and for soil stabilization.
Detachable design tends to easy maintenance and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is widely utilized in tunnels, coal mine, bridges and dams, constructing foundation, and other underground initiatives, and inflammable, explosive websites and other unhealthy environment.
It has application in chemical trade additionally to pump out chemical slurries.
The pump is electrical energy free so, can be used at any website situation whether it’s rural or urban.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment range. Generally the ultimate amount of the grouting volume is 8 or10 occasions of the amount to start with. And the ultimate grouting quantity proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s stress and flow may be adjusted in accordance with the requirements of grouting,(The move of grouting pump is 0-100L/min, pressure of discharge is 0-10MPa).apart from, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is especially used for highways, railways, water and electricity, construction, mining etc. ground/underground construction.
Benefits
Mining Pneumatic Grouting pump has the advantages of low vitality consumption, small vibration, low noise, small dimension, high efficiency, dependable performance, pressure and circulate control, long life and so forth. Common mine grouting pump has pneumatic injection pump, twin fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can also be Light weight and with a wheelie design it could be carried easily. It is designed for simple operation and low upkeep. Last however not least its spare components are simply available.
Share